Safety instructions for 3 x hose connection for PRINS/KME reducers incl. O-rings (gas and water)
1. before installing or replacing the hose connection, make sure that the gas and water supply is completely switched off.
2. before using the hose connection, check that all O-rings are intact and correctly positioned. Damaged or missing O-rings must be replaced before use.
3. use only O-rings recommended by the manufacturer to ensure proper sealing.
4. ensure that the hose connection is correctly fitted and tightened to prevent gas or water leaks.
5. keep the hose connection away from open flames or heat sources to prevent damage.
6. regularly check the condition of the hose connection and the O-rings. If there are signs of damage or wear, these should be replaced immediately.
7. observe the manufacturer's specific safety instructions in the operating instructions supplied.
8. contact the manufacturer or an authorised specialist if you have any questions or problems regarding the installation or use of the hose connection.
