Safety instructions for hose connection for PRINS and KME reducers incl. O-rings (gas and water)
1. before installing the hose connection, ensure that the gas and water pipes are properly shut off.
2. use only the O-rings recommended by the manufacturer for the hose connection.
3. check the O-rings for damage or wear before use. Replace damaged or worn O-rings immediately.
4 Ensure that the hose connection is firmly and securely connected to the reducer to prevent leaks.
5. observe the maximum operating pressures for gas and water pipes in accordance with the manufacturer's specifications.
6. do not use sharp tools or knives to install or remove the hose connection. This could damage the O-rings.
7. ensure that the hose connection is not stretched or squeezed excessively, as this may cause damage.
8. observe the applicable regulations and safety guidelines for the safe operation of gas and water pipes.
9. regularly check the condition of the hose connection and the O-rings. If there are signs of wear or damage, these should be replaced immediately.
10. if you have any problems or questions regarding the installation or use of the hose connection, please contact the manufacturer or an authorised specialist.
